E-mail:office@willingtec.com | Tel:+86-573-88197066
Home > News > Content
How To Solve The Distortion Of The Cold Forming Machine?

Cold bending machine distortion solution:

1, the deformation area of the neutral layer is accurate, the deformation area of the material used to calculate the accuracy of good wheel processing.

2, no deformation of the region as far as possible without pressure (such as the bottom of the slide), the assembly of the upper and lower rollers when the regional gap to maintain consistency.

3, the material bite before, should be based on the former road rolling state, set the guide ramp, before the steady pressure, the material slippery smooth in the roll.

4, wheel processing accuracy is the key, for this purpose, specially produced special tools in the projector, zoom 20 times to detect.

5, the main drive side, the use of roller cone bearings to ensure that the spindle radial run in the 0.04MM inside and outside, to ensure that the spindle will not be around the movement, the ordinary ball bearing their own gaps in the precise transmission can not avoid axial movement.

6, the production of bending the problem of distortion, mainly caused by uneven force, about force imbalance, left and right bending, up and down the force imbalance, resulting in distortion. Solution: design force balance, processing accuracy, easy installation and adjustment.


Contact information

ZHEJIANG WILLING INTERNATIOANAL CO., LTD 

Address: No.307,#1 West Gaoxin Rd, ETDZ,Tongxiang, Zhejiang, China

Tel: +86-573-88197066 

Phone:  +86-17757308015 

         +86-13456824686

Fax: +86-573-88196600 

E-mail: office@willingtec.com

      monica@willingint.com