E-mail:office@willingtec.com | Tel:+86-573-88197066
Home > News > Content
Safe Use Method Of Cold Bending Machine

Bending machine is a new equipment for tunnel support steel arch manufacture, is a special processing equipment in order to meet the construction section of surrounding rock and geological poor production, and random changes along with the change of surrounding rock. In the use of cold bending machine before, there are many problems need to pay attention to, below to take you to understand:

1. to choose flat mesa, stable machine, you can open the chassis feet, so that the machine panel is easy to observe. Insert the plug on the hand sensor head into the socket on the panel and tighten it. Pay attention to the notch.

2. plug one end of the power line plug into the socket on the rear panel of the chassis, and insert the other end into the power supply socket. Be sure to use the single-phase three wire power supply.

3. open the power switch on the rear panel of the chassis (POWER SW.) "," according to the panel power switch (SWITCHING) to be "ready" button, (WARM UP) "the green light, the machine can work. Hold down the "SETTING BUTTON" button, set to the appropriate value, generally between 0.5-2.0 seconds. Then the sensing head cover on the container, click on the handle of the start button, then the "heating (HEATING)" red light, said it is heated, remove the sensor head don't, "heating (HEATING)" red light is off after removing the inductive head, finally "ready (WARM UP)" the green light or in short buzzer sound a "beep" prompt and can work under a sealed container. Check the sealing quality, according to different materials, the diameter of the container and the production efficiency, the appropriate dressing "set button (SETTING BUTTON), making the best sealing quality.


ZHEJIANG WILLING INTERNATIOANAL CO., LTD 

Address: No.307,#1 West Gaoxin Rd, ETDZ,Tongxiang, Zhejiang, China

Tel:        +86-573-88197066 

Fax:       +86-573-88196600 

Phone:  +86-17757308015 

               +86-13456824686

E-mail:  office@willingtec.com

              monica@willingint.com